classic motorcycle forum

Motorcycle Discussions => Identify these bikes! => Topic started by: peb on October 16, 2011, 11:32:01 PM

Title: parts for Acme Villiers
Post by: peb on October 16, 2011, 11:32:01 PM

I am after steering colume
all rubbers,rear stand toll box
can any one help.
Regards peb

Title: Re: parts for Acme Villiers
Post by: 33d6 on October 18, 2011, 11:26:11 PM

Just make them. The steering column is easily made from a length of hydraulic tube and the tool box is a simple cylindrical job mounted under the saddle. Your rear stand is a little trickier but again, isn't complicated. The Acme is not a high speed racing bike where failure can be catastrophic. The originals were made out of ordinary materials, the same materials are still available to you to make new parts.
Cheers,