Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - brad.royce

Pages: [1]
1
British Bikes / Re: 5T primary chain case numbers
« on: July 17, 2020, 12:01:41 PM »
I’m in Westrn Australia. Plenty of unit stuff around but pre unit getting tougher.
My frame and motor are both 5T.
I can find some cases but I can’t get a definitive answer as to what will fit.

2
British Bikes / Re: 5T primary chain case numbers
« on: July 17, 2020, 05:14:47 AM »
I've been told that anything pre alternator from a rigid frame will fit? Not a lot left in Australia so don't want to fork out big money for something that won't bolt on. The bike isn't matching numbers so not requiring exact year.
Brad

3
British Bikes / Re: Triumph T120R - Help!
« on: July 16, 2020, 01:18:49 AM »
Hi mate

If it's your first classic and it runs okay once fired up maybe ensure you are starting it right.

These twins should usually start okay if you turn ignition on and hold the carb ticklers down until the fuel wells out of the carb body for each side. Once you have plenty of fuel, one kick with the clutch in to make sure you have the plates separated and then she should fire next kick.

Good fuel, charged battery, clean plug and clean / adjusted points is next steps.





4
British Bikes / 5T primary chain case numbers
« on: July 15, 2020, 02:28:23 PM »
Hi there, need some tech advice.
I have a 49 Triumph rigid frame that I am putting a 51 500 motor into.
I don’t have primary inner or outer so chasing them down is proving difficult.
Correct numbers for the 51 are T483a inner and T480a outer.
Are there any others that fit this year? I have located at T483 (no a) which is off an earlier model?
Appreciate any advice, this is my first pre unit.
Brad

Pages: [1]