1
British Bikes / Re: Triumph t140e change over model
« on: October 25, 2014, 08:41:45 PM »
Ha ha yes I know,yes they are paper thin,more of a shim really.
News:
Have you noticed we've moved..? We are now on www.classicmotorcycleforum.com. Don't forget to bookmark it!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
British Bikes / Re: Triumph t140e change over model
« on: October 25, 2014, 07:49:59 PM »
QUOTE Wilemans ,we have sold hundreds of these kits with no problems, so I get the feeling that it's ok ! It's not by the book but the brakes are 1970's so let's just hope and pray anyway.
3
British Bikes / Re: Triumph t140e change over model
« on: October 25, 2014, 11:12:02 AM »
Yes cheers, the curved stainless washer is not in the kit. I will let you know what Wilemans have to say.
4
British Bikes / Re: Triumph t140e change over model
« on: October 24, 2014, 07:18:19 PM »
OK thanks the kit I have been sent only contains the flat washer,all other parts are correct I will contact Wilemans in Derby tomorrow to ask why !
5
British Bikes / Re: Triumph t140e change over model
« on: October 24, 2014, 04:30:49 PM »
I have taken the brake master cylinders (both) to work and cleaned and polished them they are going to be fitted with new seals tomorrow however the Haynes manual does not show the correct order of assembly(the old rubbers are missing) any ideas?
6
British Bikes / Re: Triumph t140e change over model
« on: October 23, 2014, 06:24:09 PM »
Thanks much appreciated , I will get to work this weekend.
7
British Bikes / Re: Triumph t140e change over model
« on: October 22, 2014, 05:59:59 PM »
Thanks , kill switch side too , in particular do the push buttons above and below the red kill switch have a ball bearings between the small springs? Thanks again.
8
British Bikes / Re: Triumph t140e change over model
« on: October 22, 2014, 05:10:23 PM »
Do you happen to have any photos/diagrams of the internal parts of the switch gear for the T140? Mine has parts missing.
9
British Bikes / Re: Triumph t140e change over model
« on: October 20, 2014, 04:56:10 AM »
I have been told that the wiring for the kill switch can cause problems and that its best to bypass it.
10
British Bikes / Re: Triumph t140e change over model
« on: October 19, 2014, 09:27:58 PM »
Hello LAB thanks, I have been used to working on Honda's for twenty or thirty years so what might seem like simple question to some is quite a puzzle to me ! Wow what knowledge I have on hand just at the touch of a screen (not even a button now days) thanks again, where can I get hold of a couple of hemispherical washers for the handle bar assembly ? You are bang on about the Early E model because mine has points although I am fitting a Boyer system (still 36 deg's Btdc I believe) my bike was first on the road in Feb 1978, I intend ordering a V harness ASAP .Finally would you recommend that I wire the kill switch open circuit? Cheers.Paul.
11
British Bikes / Triumph t140e change over model
« on: October 19, 2014, 03:55:58 PM »
Does anyone know where I can get hold of a wiring harness for a t140e (1978) change over model , it has the ignition switch on the left headlight bracket like the V model and also the headlight switch and three warning lights are on the shell.The bike is positive earth but I am not sure that the V harness will fit and they are expensive! Also what is the correct assembly order for the handle bar rubbers and washers the bike is in a thousand bits at the moment, one other question the chrome nut that holds the yokes to the frame won't sit flush with the top yoke and leaves a gap of around 2mm I have seen other Bonnies with this gap but not all of them mostly V's. Cheers.
12
British Bikes / Re: TRIUMPH T140E SINGLE CARB KIT?
« on: September 08, 2013, 06:36:43 PM »
Did Triumph make a straight head Tiger ? If so they might have a manifold straight from the shelf .
13
British Bikes / Re: TRIUMPH T140E SINGLE CARB KIT?
« on: September 08, 2013, 02:08:44 PM »
Hello, straight head.
14
British Bikes / TRIUMPH T140E SINGLE CARB KIT?
« on: September 08, 2013, 12:30:10 PM »
Hello, is a single carb conversion available (that works) for the t140E model? cheers.
15
British Bikes / Re: Rattling brake pad's Triumph t140
« on: May 09, 2013, 07:02:53 PM »
Good tip, it works really well,thanks again.