Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Spanner

Pages: [1]
1
Autojumble / Beaded Edge wheel for sale
« on: September 19, 2012, 12:04:43 PM »
Have a 40 spoke Beaded Edge Front wheel complete with brake drum for sale. 
Do not know what it is from.
Rim outside diameter 20.25", width of rim 2".  Rim section is 'C' shaped, not Westwood section.
Condition is good.  Spokes good.
Email me for photos on mjheseltinesurf@hotmail.co.uk

2
Autojumble / 12v AIRHORNS for Sale - (not 6volt)
« on: April 10, 2008, 07:35:50 PM »
Apologies, the horns I advertised yesterday were in fact 12 volt (not 6v).  Sorry about that!!

AIRHORNS Stebel, model 'Junior'.  3 horns about 7" long and blue compressor 2.52" dia x 3.5"long.  
Please note these are 12 volts.  Very loud !!  
Price £17 inc postage.  

3
Autojumble / Panther Brass Tank Badges
« on: September 26, 2006, 06:18:58 PM »
I have a pair of good petrol tank badges for sale at £10 + p&p.
They are about 5" x 1.5" and curved to follow the tank.
They are from either a 250 or 350cc single Panther of about 1950.  
I remember that the bike had pump-up Dowty front forks.
Sorry, nothing else for that make.

4
The Classic Biker Bar / Epoxy adhesive on Cast Iron cylinder fins
« on: September 15, 2006, 01:57:35 AM »
I have a broken cooling fin on my 1926 Raleigh.  Rather than risk having the piece welded/brazed back on, does anyone have any info or experience in using epoxy to do this job.  Years ago I epoxy'ed a steel sleeve into an exhaust port OK but that was a shrink fit as well.
Any help or info would be most welcome.  
Thank you.

Pages: [1]