Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - kerabo

Pages: [1]
1
British Bikes / Villiers MW Carb
« on: September 03, 2019, 07:06:01 PM »
Has anyone had experience with the Villiers MW 2 lever carb?
I have one on a 1936 Francis Barnett.
The bike although old has done  little work. The jet and needle is correct according to the book.
If I set it to idle correctly it's trying to 4 stroke when on the last 1/4 throttle.
If I set it not to 4 Stroke it's weak at idle and slow to get away.
I was wondering what part the 2 Compensating tubes play in this?  I assume they let air in .
Would changing these for smaller make it richer at low revs?
Thanks Ken

2
British Bikes / Looking for Villiers MW carb body
« on: May 01, 2019, 06:58:02 PM »
I am in need of a MW brass bodied carb to for a FB Cruiser 39. 1936.
Just the body will do.
Inlet to the right with the tickler towards you and threaded fuel inlet away.
Threaded end for strainer.
Thanks

3
British Bikes / Clutch corks
« on: February 22, 2019, 01:54:10 PM »
Looking for 25 clutch corks for a 1936 FB Cruiser
Not available from Villiers.
 20mm top
17mm long
15mm bottom
11mm thick.

If I find some close I can make them fit.

Thanks

4
British Bikes / Villiers MW Carburettor
« on: February 21, 2019, 09:27:14 PM »
Hello
I sum searching for the small filter that fits inside the fuel Union to the carburettor on a Villiers MW Mk2 carburettor.
This in on a FB Cruiser 39.
No longer available so wonder if anyone has an old one.

Thanks Ken

Pages: [1]