« previous next »
Pages: [1]

Author Topic: Swinging Arm Removal  (Read 3658 times)

Offline PeatyMcBog

  • Advanced Member
  • ***
  • Posts: 2
  • Karma: +0/-0
  • I love YaBB 1G - SP1!
    • View Profile
Swinging Arm Removal
« on: February 20, 2006, 07:48:24 AM »
Hi all, I have a 1967 WD B40 which Im trying to remove the swinging arm with no effect seized in solid. Anyone had similar problems and managed to overcome them? Any advice would be appreciated. Im based in the West Mids Cheers Peaty
Logged

Offline TERMINATOR

  • Advanced Member
  • ***
  • Posts: 46
  • Karma: +0/-0
  • I love YaBB 1G - SP1!
    • Yahoo Instant Messenger - compmedic2004
    • View Profile
Re: Swinging Arm Removal
« Reply #1 on: June 18, 2006, 07:31:49 AM »
hi
have you managed to sort your problem out i think every one has come across this problem that have done many bikes.Case of have a go have a break dont lose ya rag  plenty wd40 big hammer plenty heat if need be.Dont think theres a lot of advice to give on this one really .
Logged

Offline gofer

  • Advanced Member
  • ***
  • Posts: 6
  • Karma: +0/-0
    • View Profile
    • Email
Re: Swinging Arm Removal
« Reply #2 on: August 25, 2006, 05:10:01 AM »
Found out that the frame fitting on my 1966 T120 Bonneville, for the swinging arm was threaded. Wondered why the bolt wouldn't come out, even after hitting with a hammer. Not sure if you have a similar set up.

Gordon
Logged
Pages: [1]
« previous next »