Motorcycle Discussions > British Bikes
Monobloc carb slides
iansoady:
My 1952 ES2 is fitted with an (incorrect) 1 1/16" Monobloc 376. It should be a 1 1/16" 276 type but I'm happy to stick with the later carb at least for the time being.
The "correct" settings for both the 276 and the 376 (which is correct for later machines) include a no 4 cutaway. I've found it runs much better with a 3.5 component although the only one I have in my fairly extensive collection of bits is well past its best.
It struck me that perhaps I could skim .030" or so off the bottom flat face of a good No. 4 slide which I have (I understand the numbers increment by 1/16" per whole number).
I appreciate this will probably ruin the slide but as they's knocking on £30 by the time VAT & postage is included I'm tempted......
mini-me:
I think its just the angled side you remove metal from, and 1/16 strikes a chord in my scrambled memory.
TGR90B:
Ian, I've got a 376 3 1/2 slide. Pm me your address and I'll send it to you. I have no use for it.
Dave.
iansoady:
That's very kind of you Dave. PM sent.
iansoady:
I did find a thread on the Vincent forum where people do seem to have a fairly relaxed attitude to this sort of thing:
https://www.vincentownersclub.co.uk/threads/amal-289-throttle-slide-cutaways.8877/
Navigation
[0] Message Index
[#] Next page
Go to full version