classic motorcycle forum

The VintageBike Message Board => Autojumble => Topic started by: Julienwarshafsky on July 13, 2011, 11:08:00 PM

Title: Wanted- excelsior cconsort exhaust pipe for pattern
Post by: Julienwarshafsky on July 13, 2011, 11:08:00 PM

Hi,
I was wondering if anyone had an excelsior consort C10 withe the 98cc villiers footchange engine, and a straightback exhaust pipe. I can't find an existing pipe to have a copy made, and would very much appreciate the opporotunity to borrow a pipe to have a copy made, unless anyone has one to sell!

Many thanks,

Julien

Title: Re: Wanted- excelsior cconsort exhaust pipe for pattern
Post by: wetdog on July 15, 2011, 09:02:04 PM

where are you

Title: Re: Wanted- excelsior cconsort exhaust pipe for pattern
Post by: Julienwarshafsky on July 18, 2011, 11:40:11 PM

I'm from the South East of England but would obviously happily pay to have the pipe shipped to me from pretty much anywhere. It would just be so much easier to have a copy made than having to take the bike to have a custom one measured up and fitted.

Title: Re: Wanted- excelsior cconsort exhaust pipe for pattern
Post by: wetdog on July 19, 2011, 04:02:22 PM

is it the same as the one on the hand change model

Title: Re: Wanted- excelsior cconsort exhaust pipe for pattern
Post by: Julienwarshafsky on July 19, 2011, 10:55:50 PM

I'm not sure. It's just a straight pipe after bending back from the exhaust port. Some models have a dog-leg bend in them, to go around the rear brake pedal. That's not the one I need. You sound as if you might have one?

Title: Re: Wanted- excelsior cconsort exhaust pipe for pattern
Post by: wetdog on July 20, 2011, 04:56:47 PM

sorry its the dog leg one i have