classic motorcycle forum

Motorcycle Discussions => British Bikes => Topic started by: Plasmaman on April 13, 2022, 04:17:30 AM

Title: CNC Plasma Cut British Bike Replicas
Post by: Plasmaman on April 13, 2022, 04:17:30 AM

I have been cutting out these motorcycle shapes with my home-made CNC plasma table, I thought I would share them here. They are approximately 19" long and cut from 1/8" thick (11 gauge) mild steel. I have identified the bikes in the pictures, although hopefully they are sufficiently detailed for that to be unnecessary. Please note that this was done totally for my own enjoyment, and I have no intention of selling them.

Full size pictures of all the bikes can be seen here:  https://motorcycleshapes.com (https://motorcycleshapes.com)

Title: Re: CNC Plasma Cut British Bike Replicas
Post by: R on April 13, 2022, 04:35:34 AM

The question that has to be asked is why aren't you selling them ?

They'd look great on a man cave wall, and there is something for nearly everyone there.
My local garden centre charges a surprisingly large wad of moolah for a rusty sheet of steel
with an anonymous pretty cut-out pattern to it.
You appear to be quite a few notches up the scale ...

Postage might be an impediment though ?

Title: Re: CNC Plasma Cut British Bike Replicas
Post by: iansoady on April 13, 2022, 03:11:22 PM

I agree, they're not my cup of tea but I'm sure there would be a ready audience.

Title: Re: CNC Plasma Cut British Bike Replicas
Post by: Rex on April 13, 2022, 05:13:20 PM

 I want to make a weather vane over the Summer as a project, and a couple of those would look good sat on top. Are you sure they're not for sale?