Show Posts
1
British Bikes / James Motorcycle Threaded Filler Cap
« on: September 18, 2009, 05:37:32 PM »
Hello, I have an (i believe) post war James Motorcycle and i am looking for a few parts. I will try to post a picture of this bike to go along with this thread.
I need a threaded Filler Cap. The tank is "for sure" threaded and measures 1-3/4 inch to the outside thread. You'll see in my pictures that i have a cap that is "twist on" but too small for my tank. I also need a headlamp lens, headlamp lens trim and the bike stand.
The James has a 10D 122cc Villiers Engine with a 3 speed gear box. the frame neck is stamped "L821" and the Villiers is stamped V15 B731 or B7310 (last stamp number is in middle of oil level check hole... tuff to read)
The bike runs sweet and i want to keep it as original as i can... but i need a gas cap. Any assistance would really help!!
Thanks, Clark clark_mb11@hotmail.com (sorrry, had to make the pic smaller to fit in this posting)
I need a threaded Filler Cap. The tank is "for sure" threaded and measures 1-3/4 inch to the outside thread. You'll see in my pictures that i have a cap that is "twist on" but too small for my tank. I also need a headlamp lens, headlamp lens trim and the bike stand.
The James has a 10D 122cc Villiers Engine with a 3 speed gear box. the frame neck is stamped "L821" and the Villiers is stamped V15 B731 or B7310 (last stamp number is in middle of oil level check hole... tuff to read)
The bike runs sweet and i want to keep it as original as i can... but i need a gas cap. Any assistance would really help!!
Thanks, Clark clark_mb11@hotmail.com (sorrry, had to make the pic smaller to fit in this posting)