Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DELONSTAINWALL

Pages: 1 2 3 [4]
46
British Bikes / Re: Excelsior Universal 125cc - Rear Plunger
« on: April 04, 2019, 12:51:19 AM »
Thank you, John.K and members,
I have compressed the large spring (top end) with the plunger upward but I cannot get the clearance to get the centre rod out of the lower frame. See photo attached. Please advise next step. Thank you Delon

47
British Bikes / Re: Excelsior Universal 125cc - Rear Plunger
« on: April 03, 2019, 10:30:31 PM »
Thank you, Members,
R, When I got this, it had no rubbers on the plunger springs top or bottom. R, the only nuts on the plunger is the two large chrome nuts and the two holding the plunger top and bottom. Iansoady thank you for the pic, didn’t help.
The plunger moves up and down the shaft. The centre rod does not move and I have tried hitting it out from the top (large spring end) and from the bottom (small spring end) but it feels like I am hitting solid metal. I don’t want to damage the rod by hitting it harder than what I have. Other pic of this motel does not have springs on them just the plunger only. When I compress the large spring the centre rod does not move.   
Please advise what I can do next Members.
 

48
British Bikes / Re: Excelsior Universal 125cc - Rear Plunger
« on: April 03, 2019, 03:44:58 AM »
HI there

Really appreciate your reply.

Unfortunately, I had tried to do exactly you have described and the central shaft does not want to move upwards. (please see attach picture)

Thank you
Delon




49
British Bikes / Excelsior Universal 125cc - Rear Plunger
« on: April 03, 2019, 01:10:15 AM »
Hi members,

I am about to work on an Excelsior Universal 125cc. That is for respray and bring it back to life again. Can someone advise me on how I could take out the rear plunger. There is one large spring on the top and on the bottom a smaller spring held onto the bike frame by two small bolts top and bottom. Any advise on how to take this out will be great.

Thank you, Delon




Pages: 1 2 3 [4]