RE: WANTED 1926 - 1927 TRIUMPH TT 500CC ENGINE SPARES

[joesengines]

Hi all, I need a couple of parts to complete my 1927 Triumph TT 500cc engine
I require a set of pushrods and pushrod tubes as well as the small aluminium covers that go on the rocker box (see picture)

I also would like to get a magneto chain cover
and possibly the correct carburettor?

If you have any of the above parts, please get in touch

Joe on- 07411190660

London, UK.

[rogerwilko]

Try this place.  http://www.veterantriumph.co.uk/default.html

[joesengines]

Hi there, thanks for that; I will get in touch with them to see if they can help

Thanks again,

Regards,

Joe.

[Rex]

They don't cater for anything post-flat-tank (1928) and they're currently not doing business anyway.

[wetdog]

I have one of these bikes i could get some parts cast up if you get really desperate , im in birmingham 
http://s1205.photobucket.com/albums/bb429/1wetdog/?action=view&current=Image001.jpg
this is how far i am with mine

[joesengines]

Hi there, thanks very much for your offer! thats very kind! I may just take you up that if I can't get any joy...

Just out of interest what carburetor is on your lovely Triumph?

Kind regards,

Joe.

[wetdog]

I have two , the one ive fitted is a large brass one , will take a look at the numbers when it comes back as im having some new pipes bent for the bike , and the tube bender has the bike (fingers crossed there ) but i wanted them to fit so armours where a none starter for me .

[joesengines]

Hi again, ok thanks very much! Do you have a contact number for yourself? Would be nice to have a chat at some point, I see you also have a Panther? I too have one, mines is a 1929 Model 50 500cc

Regards,

Joe.

[wetdog]

done that , i also have some panthers , but not a 29 very nice

[nickrudge]

Hi Guys,

I am new to this forum but am following it for some time now.

I have purchased a 1927 Triumph TT engine which is for approx. 90% complete.
Most of the parts which are missing can be made I think.
On the shock absorber I am missing the distance piece (TE17 ??) which is fitted directly against the bearing.
This piece is fitted with a small key on the drive shaft.
Can anyone help me with a small drawing and dimensions or a pattern of this distance piece ?

Regards,
Alex

[wetdog]

key 566-4 , send me your email i have the works manual already scanned will send it you

[wetdog]

i cannot open your email , try sending again or send via private message if you like, sorted now thanks , problem was this end