« previous next »
Pages: [1]

Author Topic: Bsa cush drive nut?  (Read 5775 times)

Offline Millsie1

  • Advanced Member
  • ***
  • Posts: 3
  • Karma: +0/-0
  • newbie
    • View Profile
Bsa cush drive nut?
« on: May 08, 2011, 07:24:39 PM »
Any tips of how to tighten the cush drive nut (new from srm) should be tightened to 60 llb per foot? with the bike in top gear and the rear brake on, the thing keep spinning around turning th engine.
Im completely new to this so any advise would be welcome. :-\
Logged

Offline rogerwilko

  • Advanced Member
  • ***
  • Posts: 259
  • Karma: +6/-36
    • View Profile
    • Email
Re: Bsa cush drive nut?
« Reply #1 on: May 08, 2011, 11:11:59 PM »
Tighten up your clutch springs.The clutch plates might need a clean and light sand for extra grip.
Logged

Offline Goldy

  • Advanced Member
  • ***
  • Posts: 158
  • Karma: +7/-1
  • Restore, Ride, Relive
    • View Profile
Re: Bsa cush drive nut?
« Reply #2 on: May 09, 2011, 11:53:11 AM »
You could get a piece of hard wood and wedge it between the bottom side of the drive sprocket and primary chain. As you tighten the cush drive nut, the sprocket will bit into the wood and prevent it from turning. All the best.
Logged

wetdog

  • Guest
Re: Bsa cush drive nut?
« Reply #3 on: May 13, 2011, 02:44:00 PM »
make a cluch locking tool from two old plates , very usefull
Logged

Offline VintageBike

  • YaBB Administrator
  • Advanced Member
  • *****
  • Posts: 351
  • Karma: +0/-0
  • Not quite enough bikes in the garage...
    • View Profile
Re: Bsa cush drive nut?
« Reply #4 on: May 13, 2011, 06:32:09 PM »
What model BSA is it?  I sell some clutch locking tools for the unit singles and pre-unit/unit twins.

See http://www.vintagebike.co.uk/spares/search.php?textsearch=clutch+locking&submit=Go

Cheers
Nigel
http://www.vintagebike.co.uk
Logged
Pages: [1]
« previous next »