Author Topic: TR6 wet sumping  (Read 3708 times)

Offline villa3

  • Advanced Member
  • ***
  • Posts: 8
  • Karma: +0/-0
    • View Profile
TR6 wet sumping
« on: July 23, 2011, 02:17:24 PM »
Sorted out my starting problem but now i seem to have another, my 71 TR6 is fitted with a 68 engine. When i rebuilt it i fitted a new timing breather disc and spring and oil filter plumbed up on the scavenge return. When i got the engine started it took about 3 - 5 minutes until i got a steady flow of oil back to the tank, i had filled the engine oil filter with oil as i didnt want the top end starved of oil as the engine has been rebuilt. Obviously there must have been a fair amount of oil in the sump as it spewed a fair amount out of the breather, now i have a good return i am still getting oil spitting out of the breather tube, will this clear up as i run the engine in or do i have a problem

Offline Justin_Faithfull

  • Advanced Member
  • ***
  • Posts: 108
  • Karma: +0/-0
  • ELEPHANTS - WHERE?
    • View Profile
Re: TR6 wet sumping
« Reply #1 on: July 23, 2011, 08:16:24 PM »
This will probably clear up when you have done a few miles, as there may be residual oil around the engine from the wet sumping. If this does not stop after a while then you will have to look for other causes. In the meantime don't let the oil breathe onto your rear tyre.

wetdog

  • Guest
Re: TR6 wet sumping
« Reply #2 on: July 24, 2011, 12:15:53 PM »
had the same problem on my Ariel , i was told the pipe work leading to where i had fixed the remote oil filtter ( spin on type ) was to long ? after many months of trying other things as a last resort i removed the spin on filtter and just had the tank filter , the wet sumping stopped straight away dont ask me why but im leaving the filter off .

Offline villa3

  • Advanced Member
  • ***
  • Posts: 8
  • Karma: +0/-0
    • View Profile
Re: TR6 wet sumping
« Reply #3 on: July 24, 2011, 01:22:26 PM »
I have fitted the filter behind the down tube ( OIF bike ) between the tube and swing arm pivot where most people fit it. I was thinking of removing it as a last resort although i wanted to leave it on. Before i rebuilt the engine it used to spit a bit out but the engine was pretty much shagged, i will try running the engine in first and see what happens, i dont know whether it will make any difference the way i have run the breather hose. I have been researching the Bunn breathers but what happens with the breather hose from the timed disc if you fit one.

wetdog

  • Guest
Re: TR6 wet sumping
« Reply #4 on: July 24, 2011, 09:07:14 PM »
can you feel the brether working , i also tryed the breather valve you mention , doing away with ariels ball and elbo afair , it made no difference