« previous next »
Pages: [1]

Author Topic: Identify this workshop tool please!  (Read 2163 times)

Offline Mark M

  • Advanced Member
  • ***
  • Posts: 114
  • Karma: +0/-0
    • View Profile
Identify this workshop tool please!
« on: August 05, 2019, 12:01:35 PM »
This came with a load of Enfield special tools but it's not the Crusader crank extractor that I thought it was. Could anyone identify it please? And if it's of use it's for sale as cheap as you like, or swap for anything Redditch Enfield
REgards, Mark
Note: Outer diameter 5 & 3/16" inner 2 & 1/2"
« Last Edit: August 05, 2019, 12:03:24 PM by Mark M »
Logged

Offline iansoady

  • Advanced Member
  • ***
  • Posts: 721
  • Karma: +6/-1
    • View Profile
    • Email
Re: Identify this workshop tool please!
« Reply #1 on: August 05, 2019, 01:59:54 PM »
Looks like a clutch puller to me. What's the PCD and diameter of the holes? Quite nicely made with the ball bearing in the end of the screw.
Logged
Ian
1952 Norton ES2
1986 Honda XBR500
1958-ish Tre-Greeves

Offline Mark M

  • Advanced Member
  • ***
  • Posts: 114
  • Karma: +0/-0
    • View Profile
Re: Identify this workshop tool please!
« Reply #2 on: August 05, 2019, 02:54:46 PM »
Thanks Ian, the PCD is 4 & 5/8" and (with clearance) the holes are 1/4". The whole thing is very similar to the RHS crank extractor for a RE Crusader (the right side being electrics and clutch adjustment)
REgards, Mark
Logged
Pages: [1]
« previous next »