1
British Bikes / Re: won't start backfire
« on: May 16, 2009, 05:52:33 PM »
The intake cam WAS on the wrong keyway. Thanks a million Rex.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
British Bikes / Re: won't start backfire
« on: May 14, 2009, 11:56:58 PM »
I'm running a single coil with duel outs. It fires both cylinders at the same time. Is there a way without pulling side cover off to see if the exhaust/intake cams were installed correctlly?
3
British Bikes / won't start backfire
« on: May 14, 2009, 11:29:42 PM »
I just had my 69 Triumph 650c motor rebuilt. It actually ran when I pulled it out but was starting to smoke and leaked oil bad. I put the motor back in and it will not start. It backfires through the exhaust like a shotgun blast. I run the boyer and have done all the testing to make sure it checks out. I've also rechecked the static timing, it to lines up. Plenty of spark, gas, and batteryvoltage. Can somebody please give some advice on something I might be overlooking?
Pages: [1]