1
Autojumble / Re: CZ Steering Dampner Knob
« on: August 05, 2006, 07:39:29 AM »
Thanks for the tips
Chris
Chris
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Autojumble / CZ Steering Dampner Knob
« on: August 02, 2006, 10:01:14 AM »
Hi All
I am in need of a couple of CZ (Late 40s early 50s) steering dampner knobs. With the Cz logo on them. If anyone can help please get in touch. They are some of the last bits I need to complete a couple of bikes I am working on.
Thanks for looking
Chris Quinn
(Australia)
I am in need of a couple of CZ (Late 40s early 50s) steering dampner knobs. With the Cz logo on them. If anyone can help please get in touch. They are some of the last bits I need to complete a couple of bikes I am working on.
Thanks for looking
Chris Quinn
(Australia)
3
Autojumble / Re: Late 40s early 50s CZ
« on: March 01, 2006, 05:08:58 PM »
Thanks for your reply
I am always intersted in all sorts of Cz parts especially the carbs, kickstraters and gear change levers. You should e-mail me at ctquinn@hotmail.com and then I can provide you with a list of the sort of things I am looking for. I am located in Australia, so the postage will not be to bad
Thanks again
Chris
I am always intersted in all sorts of Cz parts especially the carbs, kickstraters and gear change levers. You should e-mail me at ctquinn@hotmail.com and then I can provide you with a list of the sort of things I am looking for. I am located in Australia, so the postage will not be to bad
Thanks again
Chris
4
Autojumble / Late 40s early 50s CZ
« on: February 03, 2006, 12:43:59 PM »
I am restoring a late 40s rigid frame 125 CZ (A model engine) and a 1951 Plunger 150 CZ (C model I think). Does any one have any clues on what sort of carburettors were on the A model. It clamped to the bottom of the crankcase and if you do heve one or parts would you sell it to me. I also need kick starters and gear change levers plus assorted other parts. Leave a message if you have any ideas or parts for sale
5
Identify these bikes! / Re: Mystery Wheel
« on: February 13, 2006, 07:08:56 AM »
I also think it might be a wheel from a CZ from the late 40s
6
European and Other Bikes / Re: Need Help With 1948 Jawa Perak
« on: December 22, 2006, 12:38:44 PM »
Hello,
I think that Allan Cleaver from New Zealand would be a good place to start. He has extensive knowledge and parts for Jawa and Cz. So I think he could probably help you with the Perak as well.
His range of parts is extensive and his price is very fair.
Contact Allan by e-mail thecleavers@xtra.co.nz
Good luck
Regards
Chris Quinn
(Australia)
I think that Allan Cleaver from New Zealand would be a good place to start. He has extensive knowledge and parts for Jawa and Cz. So I think he could probably help you with the Perak as well.
His range of parts is extensive and his price is very fair.
Contact Allan by e-mail thecleavers@xtra.co.nz
Good luck
Regards
Chris Quinn
(Australia)
Pages: [1]