Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Mrgiggles

Pages: [1]
1
The Classic Biker Bar / Pictures of my 1979 Kawasaki KL250A2
« on: September 02, 2012, 08:10:50 PM »
Hey guys, wasnt sure where to post this, but i thought this bit looked good.
Just got a few photos of my kl250.
My dad gave it to my christmas 2010. been offroading a lot and ive slowly begun to turn it into more of a road goer.
Shes 33 years old and if i kept going like i was, it wouldnt see 35 :(.






Few pics off the road...








After this winter i decided to 'road go' her.












And now......




Wouldnt mind knowing what people think.
I understand what ive done (all stages) isnt everyones cuppa.
I feel doing this though will preserve (whats left) of an old KL250.
Thanks for looking.

2
Japanese Bikes / Re: 79 Kawasaki KL250
« on: August 28, 2012, 09:39:25 PM »
All the electrical bits have been swapped with new/old/spare bits. All the same symptoms.
Just to let you know, tonight ive put the super shiny clean carb back together and what do you know, runs awesome!! I'd say about 90%.
Need to time it I think and then see what's what.

OH!! Perhaps a daft question....Is the jet need suppose to sit in its seat and not move about at all?? When it was 'clamped' down, it could still wiggle about??
Cheers again :).

3
Japanese Bikes / Re: 79 Kawasaki KL250
« on: August 27, 2012, 09:33:25 AM »
It revs but struggles to do so. Pops and bangs a lot!!
I ha a feeling it may be the carb.
It's currently at my house in many pieces and soaking in white spirit :D. Will give it a blow out with my compressor when I get up my unit.

4
Japanese Bikes / 79 Kawasaki KL250
« on: August 25, 2012, 11:37:26 AM »
Hey, noob to the site and i was wondering if someone out there may be able to help me...
I have a 1979 kl250 which for a year ran pretty pissing good and i did a butt tonne of off roading.
It stood in my unit over the cold months and early this year i rebuilt it (still running good).
While i MOTd the bike, the engine it had in at the time drank a small amount of oil, so on my bench i put new rings and gaskets in my other kl engine.
After it PASSED i went ahead and swapped engines.........thats where it all went wrong :/.

It never ran properly since, i dont believe its ignition because over the past few years ive become an expert in these points and such......(hate them).

I believe its fuel and air, yesterday up my unit i got it to idle the best i think it ever has, however as soon as i give it throttle it coughs and splutters and doesnt really do anything. let go of the throttle and it goes and idles lovely again.....

Any questions you have about it, id be more then happy to answer :).

Pages: [1]