WANTED.

[Goldie]

BSA A10 Primary Drive Outer Cover (swinging arm model) wanted for project.

Does not have to be in mint condition.

Thanks.

[Goldy]

I built an A10 from bits, and of all the parts required this item was the most difficult to find. The problem is that they are so easy to damage and the material is poor quality and too thin. Problems with the cush drive or clutch cause wear from the inside and they crack beteween the inspection hole and the edge. They are difficult to repair. I finally found a perfect one at Newark Autojumble but I had to pay £100 for it. All the best.

[Blue]

Do you want the earlier plain type or the later type with clutch inspection cap?

[Goldie]

Hi Blue,
          It's not the shorter A10 plunger cover which has also 15 screw holes I require, but the later swinging arm type.

I believe that some had a clutch adjusting inspection hole, and some did not.

It does not matter if the clutch inspection hole is there or not.

Both had the large inspection hole to check for chain adjustment and oil filling.

Thanks for your interest.