Anji Mehra from Pune, India, Back again for the 53 Flash. Parts all finally together & machining all done. Would appreciate help on the following:
1) Not able to locate main roller brg, R130L which has the roller cage locked onto the inner race & the oter race has a lip on one side ( Clutch side ). Have found a similiar sized bearing No NJ 206, the only difference being that the roller cage is locked into the outer race & comes away as an assembly with the crankcase leaving the inner race on the crank. Can this be used or will there be any problems on assembling / dismantling / running ?
2) Any ideas on the end float on the gearbox lay shaft. On which end of the layshaft should this be taken up ?
Thanks in anticipation
Anji
