Author Topic: B31 Overheating?  (Read 4085 times)

Offline bsa_man

  • Advanced Member
  • ***
  • Posts: 2
  • Karma: +0/-0
    • View Profile
    • Email
B31 Overheating?
« on: July 19, 2009, 10:51:47 AM »
Hi.  I have a 1947 BSA B31 and I've just recently rebuilt the engine and started running it for short periods while I keep an eye on it.  I'm finding that although it runs smoothly, in my opinion it is starting to overheat.  What adjustments on  the carb (amal 276 type) etc do I make to try and rectify this problem?  Many thanks, Glenn

Offline Goldie

  • Advanced Member
  • ***
  • Posts: 102
  • Karma: +0/-0
  • I love YaBB 1G - SP1!
    • View Profile
Re: B31 Overheating?
« Reply #1 on: July 19, 2009, 09:53:07 PM »
Have you checked the ignition timing, running it too far retarded will cause it to over heat
« Last Edit: July 19, 2009, 09:54:14 PM by Goldie »

Offline bsa_man

  • Advanced Member
  • ***
  • Posts: 2
  • Karma: +0/-0
    • View Profile
    • Email
Re: B31 Overheating?
« Reply #2 on: July 20, 2009, 12:51:19 AM »
Hi there, no I haven't checked that but I hopefully will get a chance to tomorrow evening.  

Offline Goldy

  • Advanced Member
  • ***
  • Posts: 158
  • Karma: +7/-1
  • Restore, Ride, Relive
    • View Profile
Re: B31 Overheating?
« Reply #3 on: July 20, 2009, 04:12:13 PM »
Just to state the obvious, when you say you are running it for short periods, you do mean riding not just running stationery, when it will overheat.  As Goldie says check the ignition timing. If that's ok look at the spark plug. If it is very pale in colour or in severe cases, burnt, then the mixture is too weak. It can be made rich by screwing in the air screw (to reduce the air) If this is not enough then raise the needle by one notch ( to allow more fuel).
All the best.